75 cm Black/Linen Sheepskin Crescent Slimline girth in stock.
 
Specifically designed to fit horses with a narrow front and bulging ribcage starting directly behind the elbow. Often to be found in short backed horses, (typical for Arab Mares) where other girths don't give enough room. The Crescent girth is cut in a way that it opens to the rear in the sides and below to accomodate the far forward reaching 'bulge'. Most of these horses do not have an appreciable or no girth groove at all.
 
How to measure your horse: using a soft dressmakers tape measure, find the central groove in your horses sternum (area where the girth passes under your horses belly in line with the girth groove) and place one end of the tape measure here. Bringing the tape up firmly against your horses side, measure to approximately 5-7 inches above the point of the elbow. This will vary based on the size of your horse: the larger the horse, the higher you measure to. Then multiply this measurement by 2 and select the size girth closest to your measurement. It can be helpful to put your saddle pad on your horse. You will find that the buckles of your new girth will only be a couple of inches below the bottom of your pad (see photo example). Do not worry if you only have a couple of holes left in your girth billets when your girth has been fully firmed-up. This is desirable and really quite necessary, otherwise the elbow relief area will be too low and the ergonomic benefits lost.
 
Many horses are very sensitive in the sternum area, resulting very often in problems when saddling as well as when riding.

We have realised, during our long term studies that many girths are not really functional , and in some cases have an  adverse effect! Many girths look correctly designed but are in effect, in most cases, not.
 
Others are obviously faulty in design. One of the basic problems we found, was that the pressure distribution on the sternum was ineffective. The pressure is actually only concentrated along the centre line on the sternum, sometimes only about 2-3 cm wide.

The MATTES© Contoured Saddle Girth is made of a system of internal straps working against a plastic centre piece, resulting in absolutely equal pressure distribution on the sternum.  The textile structure also has good flexibility despite a relatively rigid construction. There is also the chafing problem in the elbow area, with barrel shaped horses, where the girth has a tendency to slip forward. Generally a contoured girth with a narrow waist in the elbow area is ideal in this case. Additional SOFT-EDGE with LAMBSKIN result in an ideal product.

Specifically for strong barrel shaped horses, we have developed our Crescent-Girth, which has a more extreme cut back in the elbow region to allow free elbow movement without any hindrance. This girth is devised so that the rear part is wider than the front part, to ascertain that the greater bulk in the rear can be accommodated , this way the girth loses its tendency to slip forward.

This girth was developed because we were constantly approached by horse owners with horses with the beginning or already chronic, 'Equine Sarcoid' in the elbow area.